Filter
Top Products
ACCESSORIES
A-5A-5
LN-23P
POWER SOURCE
One or two LN-23Pʼs can be connected to a DC power source (constant voltage) with a K-350 or K350-1 Adapter
Kit. If two LN-23Pʼs are connected, they can be set for different procedures but only one can be used at a time.
Power source connection diagrams:
M17323
M14272
S25869
S25149
LN-23P/ Power Source Combinations
1. Classic II, Classic III, Classic IIID, or SA-250 with K350-1 Adapter Kit and K623-1 Wire Feed Module.
2. Commander 300, Commander 400 or Commander 500 with K350-1 Adapter Kit.
3. Ranger 250 , Ranger 275, or Ranger 305G with K350-1 Adapter Kit.
4. CV-300, CV305, CV-400, DC-400, DC-600, DC655 or V300, V350 Pro, V450 Pro with K350-1 Adapter Kit.
NOTE: The K350 must be used on power sources with terminal strip connections only.
K316L-2 may not require a K350-1 adapter if the power source has a Lincoln 14 pin connector.
5. SAE-400 or SAE-400 Weld ʼN Air with K316L-2, K385-1, 2 CV Adapter & K350, K2379-1 Adapter Kit.
NOTE: Only allows for one LN-23P feeder.
Gun will always be HOT when SAE-400 is running.
6. SAE-400 with a K385-1 and a K350 Adapter.
NOTE: K350 will have to be powered from 120VAC receptacle (customer responsibility).
No remote control of weld voltage from LN-23P
Gun will always be HOT when SAE -400 is running
7. LN-23P (K316L-2) used with V350-Pipe does not require a K350-1 Adapter.
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC