Filter
Top Products
AUTO-PLANE
R
1.
Removing
the
blades
Loosen the hex bolt which secures the
chip cover and open the chip cover.
Open the safety cover over the jointer
and rotate the drum by turning the
knob until the drum can be locked in
the position whereby the blade installa-
tion bolts face upward.
The magnetic holder has
a
different
shaped claw on each side. Use the cor-
rect claw for auto-planer.
Knob
1
Hex bolt
Blad; installation bolt
For jointer
Claw
M
Magnetic holder
I
Place the two magnetic holders on the
set
plate and push them in the direction of the
arrow until the claw contacts the blade. Remove the eight blade installation bolts using
the socket wrench. Grip the magnetic holders and raise them straight up to remove the
set
plate and blade from the drum. Press the lock plate and rotate the drum by turning
the knob
180"
to lock the drum. Remove the other blade
as
described above.
I
Blade installation bolt
-
Socket wrench
L
Magnetic holders
12