Filter
Top Products
Loosen the clamp screws which secure
I
the fence. Remove the fence. Align the
line on the coupling with the pointer on
the frame of the jointer.
Coup1 ing
s
Line
eoin
t
e
r
Align the two shafts of the jointer with the mating holes in the auto-planer. Push the
jointer toward the auto-planer until the frame of the jointer contacts that of the auto-
planer. Make sure the jointer
is
correctly installed on the auto-planer
by
viewing the
contact portion through the notch. Tighten the knobs to secure the jointer. Re-install
the fence and tighten the clamp screws to secure the fence.
Mating
r
‘lamp
Screw
Knob
-/
-Shaft
of
jointer
See this contact portion
2
through notch.
Knob
20