Filter
Top Products
JOINTER FUNCTIONS:
Extension support table
The extension support table
is
convenient
for cutting long workpieces. Install
it
on
the outfeed table and semi-tighten the four
hex bolts. Extend the
legs
and hook the
arms over the screw using the hook
(A).
Then tighten the screws securely. Adjust
the table height using the knobs
so
that the
extension support table
is
level with the
outfeed table. Then tighten the wing nuts
securely. After adjusting the table height,
tighten the four hex bolts securely.
When moving the tool, fold the extension
support table
as
follows.
First fold the extension support table
as
shown in the figure. Tighten the two hex
bolts securely. While holding the
legs,
loosen the screws and unhook the arms
from the screw. Fold the legs and hook the
arms over the screw using the hook
(6).
Then tighten the screws securely.
Adjusting the depth
of
cut
The depth of cut can be adjusted from
0
mm to
3
mm
(1/8").
Align the pointer to
the desired graduation on the
scale
plate by
turning the depth adjusting knob. The in-
feed
table
is
lowered for increased depth of
cut by turning it clockwise and raised by
turning it counterclockwise.
I
Extension support table
7
Hex bolts
Hook
(A)-,
1-
Arm
Screw
VI
I
;Hex
bolt
Scale plate
1
L
Depth adjusting knob
9