Filter
Top Products
2.
Installing the blades
Provide
a
flat wood block approx.
150
mm
(5-29/32")
long and
100
mm
(3-1
5/16")
wide.
Place
the blade and
set
plate on the wood block
so
that the
blade locating lug of the
set
plate rests
in the groove of the blade. Adjust the
set
plate
so
that both ends of the blade
do not protrude from the ends of the
set
plate. Place the two magnetic holders
on the
set
plate and push them until the
claw contacts the blade. (Note: Use the
correct claw for jointer.)
Lock the drum in the position whereby
the blade installation bolts face upward.
Place the
set
plate and blade on the
drum
so
that the heads of the depth
adjusting screws in the drum fit into the
square holes in the
set
plate. Remove
the magnetic holders while holding the
set
plate with your hand.
Place the drum plate on the
set
plate.
Install the blade installation bolts and
semi-tighen them.
16