Filter
Top Products
FOR
JOINTER
1.
Maintain the proper relationships of infeed and outfeed table surfaces and
cutterhead blade path.
2. Do not perform jointing operations on material shorter than
140
mm (5-1/2
inches), narrower than
19
mm (3/4 inch), or less than 12.7 mm (112 inch) thick.
3.
Do not perform planing operations on material shorter than 140 mm (5-1/2
inches), narrower than
19
mm (3/4 inch), wider than 155 mm
(6-1/8
inches)
or thinner than 12.7 mm (112 inch).
4.
Support the workpiece adequately at all times during operation; maintain
control of the work at all times.
5.
Do
not back the work toward the infeed table.
6.
Do not attempt to perform an abnormal or little-used operation without study
and the use of adequate hold-down/push blocks, jigs, fixtures, stops and the
like.
FOR AUTO-PLANER
1.
Two or more pieces of narrow but similar thickness stock can be passed
through the auto-planer side by side.
However, allow some spacing between the stock to permit the feed rollers
to grip the thinnest piece.
Otherwise, a slightly thinner piece could be kicked back by the cutterhead.
2.
Determine the depth of cut according to the table shown on the front of the
tool. Do not attempt to cut more than the specified amount in one pass.
WARNING
For Your Own Safety, Read Instruction Manual Before Operating Jointer
1.
Wear eye protection.
2.
Never perform jointing or planing operation with cutter head or drive guard
3.
Never make jointing or planing cut deeper than
3
mm (118 inch).
4.
Always
use hold-down/push blocks for jointing material narrower than 76.2
removed.
mm
(3
inches), or planing material thinner than 76.2 mm
(3
inches).
SAVE THESE INSTRUCTIONS.
5