Filter
Top Products
Lock the drum in the position whereby
the
blade edge faces upward. Place the
triangular rule flat on the outfeed table.
Turn the adjusting screws until the
blade edge just contacts the triangular
rule. After adjusting both adjusting
screws, pull the lock pin to unlock the
drum. Rotate the drum by turning the
knob clockwise to make sure the blade
protrusion
is
at
exactly the same height
all
the way across.
If
not, adjust the
adjusting screws again.
After carefully adjusting the blade pro-
trusion, lock the drum in the position
whereby the blade installation bolts
face upward. Securely tighten the blade
installation bolts evenly from the center
of the outside.
Then slightly retighten the adjusting
screws by turning clockwise.
Outfeed
table
I
17