Makita 2030S Planer User Manual


 
2.
Installing the blades
Provide
a
flat wood block approx.
300 mm (1 1-13/16") long and
100
mm
(3-15/16") wide. Place the blade and
set
plate on the wood block
so
that the
blade locating lug of the
set
plate rests
in the groove of the blade. Adjust the
set
plate
so
that both ends of the blade
protrude approx. 1 mm (3/64") beyond
the end of the
set
plate. Place the two
magnetic holders on the
set
plate and
push them until the claw contacts the
blade (Note: Use the correct claw for
auto-planer.
Grip the magnetic holders and slip the
heel of the
set
plate into the groove in
the drum. Install the blade installation
bolts.
After tightening all the blade installa-
tion bolts lightly and evenly from the
center to the outside, tighten them com-
pletely following the same sequence.
Remove the magnetic holders from the
set
plate.
I
Magnetic holder
Set
plate
(3/64")
Blade
~
Blade installation bolt
Magnetic holder
-Socket wrench
Magnetic holders
13