Filter
Top Products
17
Attach Sawdust Chute
1. From among the loose parts find the following:
1 Sawdust Chute
2 Wing Screw 1/4-20 x 1/2
1 Wrench Box 8mm/10mm
1 Wrench Hex-“L” 3mm
2. Slide the tab on the bottom side of the dust chute into
the slot just below the chute on the left side of the
base. Fasten the dust chute on with the 2 wing screws
through the slots on both sides of the dust chute.
3. The 3mm hex-L wrench and 8mm open end wrench
(supplied with the jointer) used for blade adjustments,
can be conveniently stored in the dust chute as shown.
NOTE: If a dust collection system is not in use, simply
loosen the two wing screws, lift the bottom of the chute
up, out and then slide the dust chute up and retighten the
wing screws.
Adjusting Table Extension
The table extension is adjusted at the factory and should
not require any additional adjustments. In the event that it
shifted during shipping, align it to the outfeed table as fol-
lows.
1. Loosen the 2 hex head screws that attach the exten-
sion to the outfeed table.
2. Using a straight edge, align the extension to be flush
with the outfeed table.
3. Tighten the two screws and recheck the alignment.
Sawdust Chute
Screw Wing
1/4-20 x 1/2
Tool
Storage
Extension even with
outfeed table
Outfeed
Extension
Socket Head
Screw
Table