Filter
Top Products
13
Mounting Right Side Table Top
1. Find the following:
1 Particle Board Table Top
2. From the loose parts package find the
following:
4 M6 x 1.0-45 Carriage Bolts
4 M6 x 1.0 Hex Head Nuts
4 6.5 x 19 x 1.6 Flat Washers
4 6mm Lockwashers
3. The right side mounts similar to the left
except there is no steel support plate.
4. Place carriage bolts, through the table
top holes B and D as shown. Align the
right side table top with the left side
table top so that the two halves join end
to end. Fasten in place with a washer,
lockwasher and nut.
5. Securely tighten all nuts and bolts.
6. Adjust leveling feet as follows:
a. Move legset to desired location.
b. With a 14mm wrench loosen bottom
nut.
c. Back off top nut by hand.
d. Raise or lower foot by adjusting bot-
tom nut using 14mm wrench.
e. Snug top nut against inside of leg by
hand.
f. Tighten all four bottom nuts using
14mm wrench.
Particle Board Table Top
Carriage Bolt
M6 x 1.0-45
Flat Washer Nut He
x
6.5 x 19 x 1.6 M6 x 1.
0
Lockwasher
6mm
Motor Mounting Plate
Left Side
Right Side
A
B
B
C
D
D
C
Table Top
Table Top
C
C
C
A