Filter
Top Products
7
Motor Specifications and Electrical Requirements
Power Supply and Motor Specifications
This Lathe is designed to use a 1725
RPM motor only. Do not use any motor
that runs faster than 1725 RPM.
WARNING: To reduce the risk
of electrical hazards, fire hazards
or damage to the tool, use proper
circuit protection. Your tool is wired
at the factory for operation using
the voltage shown. Connect tool to
a power line with the appropriate
voltage and a 15-amp branch cir-
cuit. Use a 15-amp time delay type
fuse or circuit breaker. To reduce
the risk of shock or fire, if power
cord is worn or cut, or damaged in
any way, have it replaced immedi-
ately.
The A-C motor used on this tool is a
totally enclosed fan cooled (TEFC), induc-
tion nonreversible type, having the follow-
ing specifications:
General Electrical Connections
DANGER: To reduce the risk of
electrocution:
1. Use only identical replacement
parts when servicing. Servicing
should be performed by a quali-
fied service technician.
2. Do not use in rain or where floor
is wet.
This tool is intended for indoor
residential use only.
WARNING: To prevent electric
shock, do not permit fingers to
touch the terminals of plug when
installing or removing the plug to or
from the outlet.
110-120 Volt, 60 Hz. Tool Information
NOTE: The plug supplied on your tool
may not fit into the outlet you are planning
to use. Your local electrical code may
require slightly different power cord plug
connections. If these differences exist
refer to and make the proper adjustments
per your local code before your tool is
plugged in and turned on.
In the event of a malfunction or break-
down, grounding provides a path of least
resistance for electric current to reduce
the risk of electric shock. This tool is
equipped with an electric cord having an
equipment grounding conductor and a
grounding plug, as shown. The plug must
be plugged into a matching outlet that is
properly installed and grounded in accor-
dance with all local codes and ordi-
nances.
Do not modify the plug provided. If it will
not fit the outlet, have the proper outlet
installed by a qualified electrician.
Rated H.P 1/2
Voltage 110-120
Amperes 8.0
Hertz (Cycles) 60
Phase Single
RPM 1725
Rotation of Shaft Clockwise