Filter
Top Products
15
7. Locate Hole F on the left table board.
Attach the bracket plate to the table
top through Hole F. Use an M6 x 1.0-
45 carriage bolt, washer, lockwasher
and nut. Finger tighten.
8. Locate the three holes Labeled G on
the lower edge of the belt guard plate.
Place a M4 x 0.7-6 screw through
each of these holes and into the
tapped holes in the plate support.
9. Replace pulley on headstock tighten-
ing with 4mm hex “L” wrench.
10. Securely tighten all nuts and bolts.
Mounting the Motor
1. Find the following:
1Motor
1 Motor Pulley
2 Cord Clamps
1V-Belt
2. From the loose parts package find the
following:
2 M4 x 0.7-6 Pan Head Screws
4 M6 x 1.0-16 Carriage Bolts
4 6.5 x 19 x 1.6 Flat Washers
4 6mm Lockwashers
4 M6 x 1.0 Hex Nuts
1 M8 x 1.25-8 Socket Set Screw
1 4mm Hex “L” Wrench
G
G
G
M6 x 1.0-12
Hex Head Screw
M6 x 1.0-45
Carriage Bolt
Carriage Bo
lt
M6 x 1.0-16
Motor
Hex Nut
M6 x 1.0
Pan Screw
M4 x 0.7-6
4mm Hex “L”
Lockwasher
6mm
Washer
6
.5 x 19 x 1.6
Socket Set Screw
M8 x 1.25-8
V-Belt
Motor Pulle
y
Cord Clamp
Wrench