Filter
Top Products
21
Key Functions in Normal Display Mode
“FUNC” = By pressing it, the display changes from
“Normal Display Mode” to “Parameter
Display Mode.”
= Pressing it for more than ten seconds
initiates the Lamp Test. During the
Lamp Test the device functions normally
while all display segments and LED's
are lit with a 50% duty cycle. No timeout
is applied to a lamp test.
Press the "FUNC" key again to end the
Lamp Test.
" " or “ " = By pressing these keys it is possible to
change the displayed information. See
“Normal Display Mode” on previous page.
“RESET” = Press and hold for 1 second to initiate
“reset.”
Parameter Display Mode
The "FUNC" key initiates the Parameter Display Mode
when pressed for less than 10 seconds in the "Normal
Display Mode."
The lower display shows the parameter identification
code while the upper display shows the parameter value.
The value of these parameters can be modified with the
and keys.
Press the "FUNC" key again to store the new value and
advance to the next parameter.
If no keys are pressed within the timeout period (see t1),
the display will automatically return to the "Normal Dis-
play Mode" in the previous display and any modifications
of the last displayed parameter will be lost.
All parameters (except
) can be modified only when the
device is UNLOCKed.
The LOCK/UNLOCK status can be selected in configura-
tion using parameter n1 or during the operating mode
with the parameter password.
To switch from LOCKED to UNLOCKED, enter the n1
parameter setting. To switch from UNLOCKED to
LOCKED, enter any number other than the n1 parameter
setting.
When the device is in remote (the serial link controls the
device) no parameters can be modified.
Key Functions in Parameter Display Mode
FUNC = Press the “FUNC” key again and the
instrument stores the new setting
(if changed) and goes to the next
parameter.
or = Changes the setting of the selected
parameter.
RESET = Press and hold for more than 1 second to
initiate reset.
7sl-3-00.p65 9/17/02, 2:41 PM21