Filter
Top Products
26
SPECIFICATIONS
Case RABS Grey dark color (RAL 7043).
Self-extinguishing degree V0
according to UL 94
Front panel Designed and tested for IP65 and NEMA
4X for indoor location (when panel gasket
is installed). Tests were performed in
accordance with IEC 529, CEI 70-1 and
NEMA 250-1991 STD.
Installation Panel mounting
Rear Terminal Block
15 screw terminals with safety rear cover
Dimensions Unit with RS-485 communications
DIN 43700 48 x 48 mm x 122 mm
(1.890 x 1.890 in. x 4.803 in).
Dimensions Unit without RS-485 communications
DIN 43700 48 x 48 mm x 105 mm
(1.890 x 1.890 in. x 4.134 in).
Cutout 45 x 45 mm (1.772 x 1.772 in).
Weight 250 g (8.75 oz).
Upper Display 4 digits, 7 segment red LED’s with
decimal point, 7.62 mm high (0.3 in).
Lower Display 2 digits, 7 segment red LED’s with
decimal point, 7.62 mm high (0.3 in).
Indicator 2 red LED annunciators for:
“RESET” Indicates control output status
as follows:
a) With configuration parameter
C2 = 0
LED ON when Output is OFF
LED OFF when Output is ON
b) With configuration parameter
C2 = 1
LED flashes when Output is OFF
LED ON when Output is OFF
and acknowledged
LED OFF when Output is ON
“ALM” indicates alarm status as follows:
Flashes when alarm is ON.
ON when alarm has been
acknowledged
OFF when alarm is OFF
RMT A decimal point on the right side
of the upper display flashes to
indicate the device is controlled
by serial link
Keyboard Four keys (covered by polyester mem-
brane) labelled RESET, , & FUNC.
Power Supply 100 to 240 Vac 50/60 Hz switching or
24 Vac/Vdc with interruptions less than
100 ms
Power Supply Variation
-15% to 10% (for 100 to 240 Vac)
-10% to 10% (for 24 Vac/Vdc)
Power Consumption 8 VA max
Insulation Resistance Greater than 100 MΩ
Insulation Strength1500 V rms for 1 minute
EC Compatibility
Conforms with 89/336/EEC directives re-
garding electro-magnetic compatibility
Emission Complies with:
Generic emission standard EN50081-2
Immunity Complies with the generic im-
munity standard EN50082-2. Conforms
with 72/23/EEC and 93/68/EEC directives
regarding low voltage. It complies with the
safety requirements for electrical equip-
ment for measurement, control and
laboratory use, Generic Standard
EN61010-1, Installation Category II.
Sampling
Time 250 ms for linear input
500 ms for TC/RTD input
7sl-5-00.p65 9/17/02, 2:43 PM26