Tektronix TSG 601 Welding System User Manual


 
TSG 601 User Manual
1
Getting Started
Please note the following statements before using your TSG 601.
CAUTION. Attempting to operate the TSG 601 with an improper AC
adapter can result in damage to the instrument. To avoid damage,
USE ONLY AN APPROPRIATE DC POWER SOURCE: Voltage must
be 9 to 15 VDC; the connector must have the NEGATIVE contact in
the center; and open-circuit voltage of the power source must not
exceed 18 VDC.
For best results, use the AC adapter that is supplied with the instru-
ment. If the supplied adapter is incorrect for the local AC power sup-
ply, contact your nearest Tektronix representative.
WARNING. Install or replace batteries only with the instrument
switched OFF and the AC adapter disconnected.
Replace the batteries only with standard AA batteries (1.2–1.5 V,
nominal), or with the optional rechargeable battery pack.
If you use NiCad AA batteries or the optional battery pack, be sure to
set the battery type to “rechargeable” through the diagnostic menu
(see page 56). Failure to do so can result in damage to the batteries.
NOTE. Do not disconnect the AC adapter when the TSG 601 is
switched on. Some user settings may be lost, perhaps causing unex-
pected results the next time the instrument is switched on.
If you have any questions regarding the operation of this instrument,
please contact your nearest Tektronix representative or field office.
In the United States and Canada, you may also call the Tektronix
information number, 1-800-TEK-WIDE (1-800-835-9433), between
8:00 am and 5:00 pm Pacific time.