Filter
Top Products
Operating Basics
12
TSG 601 User Manual
4. Use the
Y / B keys to select the number of the ID to appear
during each interval. Choose the hyphen (it’s below #1) to
eliminate the interval. If you want a blank interval (that is, a time
gap between ID messages), you must create an all-blank ID to put
in that interval.
5. When the correct information is in all four time interval posi-
tions, press
ENTER to confirm the cycle setup. (Press any rectangu-
lar key to abort the cycle edit.)
6. To set the duration of each cycle time interval, press the
Y key to
reach the “ID Cycle time” menu item. Use the horizontal arrow
keys to select the duration between one and nine seconds. Press
ENTER to confirm.
7. To replace the current ID with the ID cycle, scroll through the ID
menu to the “ID Cycle OFF” selection. Press a horizontal arrow
key to change the selection to “ID Cycle ON,” then press
ENTER.
The cycle will appear in the picture if toggled on with the “ID
On/Off” key.
Inserting Embedded Audio
H Press the “Audio On/Off” key to alternately enable and disable
embedded audio in the serial data stream.
Though the TSG601 will provide 16 channels of audio, it can only
output a maximum of 4 channels at a time. Therefore the 16 chan-
nels have been broken up into 4 Groups of 4 channels each. Please
read “Embedded Audio” on page 19.
1. Enter the Audio menu (press
Shift, then Audio On/Off). The display
will look something like this:
2. Go into the Audio Group Selection menu by pressing the ENTER
key. The display will change to: