Filter
Top Products
Operating Basics
TSG 601 User Manual
7
2. Power the TSG (page 3) and switch it on. By default, the instru-
ment will begin with most settings that were in effect when it was
switched off. Two exceptions: all video component channels will
be ON (see page 8); and the output amplitude will be 800 mV.
3. Select the appropriate serial video standard (625/50 or 525/60)
through the Diagnostic menu (pages 56, 58).
4. Return to normal operation by pressing the Test Signals key.
5. Select the desired test signal one of three ways:
G Press the Test Signals key repeatedly until the name of the
signal you want appears on the display. The signal will be
output as soon as the name is visible. Or...
G Use the
Y and B keys to scroll through the list of signals until
you get to the desired signal. Or...
G Press the appropriate letter key (A through P) to “Direct-Se-
lect” the signal. The available signals and their corresponding
keys are listed below.
Test Signal Direct-Select Key
75% Color Bars A
100% Color Bars B
Pluge 1 (BBC 1) C
Pluge 2 (BBC 2) D
5-Step Staircase E
Limit Ramp F
Shallow Ramp G