Filter
Top Products
Operating Basics
8
TSG 601 User Manual
Direct-Select KeyTest Signal
Modulated 5-Step H
Modulated Pulse and Bar I
60% Line Sweep with Markers J
Bowtie K
Convergence L
Equalizer SDI Checkfield M
PLL SDI Checkfield N
Matrix SDI Checkfield O
Active Picture Markers P
Adjusting the Output Amplitude
1. Press the key marked “Output Ampl.”
2. Select the desired output level with the arrow keys. The
Y / B
keys change the level to the next higher or lower 100 mV
increment;
A / " keys change it in 20 mV increments. Holding
an arrow key down will continually increase or decrease the level
until it reaches its minimum or maximum.
3. Press any rectangular key to exit the Output Amplitude Adjust
function.
Controlling the Video Component (Y, C
r
, C
b
) Channels
1. Enter the Output menu (press
Shift, then Output Ampl.) and press
ENTER to reach “Channel Output Selection.” The display will
look something like this:
2. Use the A and " keys to position the flashing underline cursor to
the status (ON or OFF) of the channel you wish to change.