Filter
Top Products
Operating Basics
TSG 601 User Manual
11
Positioning ID Messages
NOTE. Only the position of the currently displayed ID may be
changed. If you wish to change the picture location of a message that
is not displayed, you must first recall it through the ID menu or the
Recall menu.
1. Enter the ID menu (press
Shift, then ID On/Off), if necessary.
2. With the
Y and B keys, scroll to the “Position ID” menu item.
3. Press
ENTER.
4. Use the arrow keys to move the message horizontally (H) and
vertically (V) in the picture.
5. When the ID occupies the desired position, press
ENTER to save
the new location in memory and return to the ID menu. If you
press any rectangular key instead of
ENTER, the ID will remain in
its new position—but will revert to the original location the next
time it is recalled from memory.
6. As usual, press any rectangular key to exit the ID menu.
Setting up an ID Cycle
1. Edit and save the ID messages that you want to cycle (see
“Editing ID messages,” page 10). Note the numbers of the IDs,
and the order in which they should appear.
2. Scroll through the ID menu to reach the “ID Cycle Setup” item,
then press
ENTER. The display will resemble the following
illustration.
3. Use the A / " keys to move the underline cursor to one of the
four sequence “time intervals.” The IDs will appear in the order
that their numbers appear (from left to right) on the display.