Filter
Top Products
STE 58761
－ －
2-5
(4) Procedure
(a) Step 1: Turn on the main power
First, make sure that the system disk is not in the FDD unit (option). Then,
turn on the controller main power. The POWER lamp and the SERVO
POWER OFF lamp on the control panel will light up.
The controller will start initializing the system. The disk drive light will blink for
about 15 seconds.
When the hot start operation is completed, the STOP lamp on the control panel will
light up and the LCD (liquid crystal display) of the teach pendant will display the
initial mode selection menu.
POWER
ON
OFF
SERVO POWER
FAULT
STOP START
EXT
INT
MANU
BATTERY
ALARM
CYCLE
STOP
EMERGENCY
POWER
10AT
The lamp
turns on