Filter
Top Products
Prestige 128MH PSTN Router/Hub
System Maintenance 13-15
13.7.1 Upload RAS code
RAS (Remote Access Service) code refers to the firmware that controls the main function of the
Prestige. Menu 24.7.1 shows you the instructions for uploading RAS code. If you answer yes to
the prompt, the Prestige will reboot automatically. Press any key when you see the message
“Press Any key to enter Debug Mode within 3 seconds.” to enter debug mode.
Once in debug mode, type atur and wait for your Prestige to respond with “Starting XMODEM
upload” to begin uploading the new firmware (upload procedure varies depending on the software
used to access your Prestige). After successfully uploading the new firmware, type atgo to
restart your Prestige.
Figure 13-11. Menu 24.7.1 - Uploading RAS Code
Menu 24.7.1
--
System Maintenance
-
Upload RAS Code
To load the RAS code, type "atur" while in debug mode and wait
for "Starting XMODEM upload" before beginning to upload code.
Type "atgo" after code has successfully loaded to start RAS.
Proceeding with the upload will erase the current RAS code.
Do You Which To Proceed:(Y/N)