Filter
Top Products
60
.
Pre-Cut Locator
Allows you to mark and locate exactly where the blade will enter
the workpiece.
Always make sure table saw is turned off and unplugged.
Set blade
1 at 90 degrees square to table. Using a straight edge
and a soft pencil, place straight edge
2 against both sides of
b
lade and mark lines on locator
3
(
Fig. 47). These lines indicate
the “path” of the cut (kerf) made by the blade.
W
hen cutting the workpiece, line up mark on workpiece with the
line on the disc (Fig. 48).
90
30
45
60
75
75
60
45
30
FIG. 47
FIG. 48
Using The Rip Fence Pointer
When Table Is Not
Extended
The rip fence pointer shows the distance from the blade to rip fence
through a convenient viewing and magnifying window.
Align rip fence pointer
4 with lower portion of scale 5. The lower
scale can be used for widths up to 13.5 inches (Fig. 49).
Using The Table Pointer
When Table Is Extended
The upper portion of scale 6 is used for rip cut 13.5 to 25 inches.
Align table pointer
7 with upper portion of scale 6 (Fig. 49).
Making Rip Cuts Beyond 25
Inches Without The Use Of Scale
When positioning fence for maximum rip without the use of scale,
loosen screw
8 and lower plate 9 below the head 10 of the rip
fence
11 (Fig. 49). DO NOT rip or cut dados or moldings with the
fence beyond this position because it cannot be locked.
FIG. 49
1
3
2
4
5
6
7
8
9
10
11