Filter
Top Products
80.
To reduce the risk of injury, never use a
s
ingle dado blade for normal saw thru-
cutting. Never use chippers without both outside cutters.
Read and follow all Operation/Safety Instructions included
with the dado set.
NOTE:
The arbor nut must be fully engaged on shaft threads. If
the stacked width is more than 1/2", do not use the table saws'
i
nner washer. Instead, use the accessory dado washer. With this
saw, do not exceed a stacked width greater than 13/16”.
7.Lower the blades below the table top and insert the Bosch
Dado Table Insert (TS1007) (Fig. 70). Raise the cutters to the
d
esired depth of cut (above the insert). Check that the tool is
not plugged into a power source; then carefully rotate the
cutters by hand to make sure all components are tightly held
a
nd no interferences exist.
8
. Plug saw into power source. Using scrap wood, make practice
dado cuts and adjust height accordingly.
To reduce the risk of injury, never pass your
hands over the cutting dado blades.
Dado
cuts are non-thru (blind) cuts. Many times the cutters cannot be
seen during cutting. See page 76 for instructions on Non Thru-
sawing.
To reduce the risk of injury, never make
freehand cuts.
The work piece must be held
against the saw's fence or miter gauge as it is being fed.
Whenever possible, use push sticks and push blocks for cutting
(see page 74). Always use feather boards, attached to the table
or fence, when rip cutting (See page 76). When cross cutting,
firmly hold work piece against the miter gauge
(see page 66).
NOTE: Because dado cuts are non-thru cuts, the miter gauge
can be used with the fence locked in place. This is helpful when
making repeat dado cross-cuts from the ends of more than one
work piece. Each piece is held against the miter gauge and its
end slides along the fence at a preset distance.
Depending on the final depth of cut and/or the density of the
material, it may be required to make multiple cuts starting with
small depths of 1/4” to 1/2” and progressing to final depth. When
performing extensive repetitive dado cutting, periodically check
the work pieces to see that the depth of cut is maintained.
RETURNING SAW TO NORMAL THRU-CUTTING
After completing your Dado cutting, be sure to return the inner
and outer washers to the original positions (see page 30 for
details). It is important that the original equipment washers are in
the proper positions so that the saw blade always aligns with the
permanently installed riving knife.
ADJUSTABLE OR WOBBLE DADO SETS
To reduce the risk of injury, do not use
adjustable or “wobble” dado sets on this
saw.
Adjustable dado sets can be easily set to positions that
may interfere with working components of this saw.
WARNING
!
WARNING
!
WARNING
!
WARNING
!
FIG. 69
FIG. 70
U
SE INNER WASHER
U
TILISER UNE RONDELLE INTERIEURE
U
SE LA ARANDELA INTERIOR
DADO TABLE INSERT
PLAQUE AMOVIBLE DE
TABLE POUR RAINURAGE
ACCESORIO DE INSERCIÓN
DE LA MESA DE MORTAJAR
1
/2” OR LESS
1
/2 PO OU MOINS
1/2 PULGADA O MENOS
G
REATER THAN 1/2”
M
AX 13/16”
PLUS DE 1/2 PO MAX. 13/16 PO
M
AYOR DE 1/2 PULGADA
MÁX. 13/16 DE PULGADA
U
SE ACCESSORY DADO WASHER
UTILISER UNE RONDELLE ACCESSOIRE
POUR LAME A RAINURER
USE LA ARANDELA ACCESORIA PARA
M
ORTAJAR