Filter
Top Products
3-9
Cisco ASR 901 10G Series Aggregation Services Router Hardware Installation Guide
OL-28105-02
Chapter 3 Installing the Cisco ASR 901 10G Router
Mounting the Cisco ASR 901 10G Router
For the best support of the router and cables, make sure that the switch is attached securely to wall studs
or to a firmly attached plywood mounting backboard.
Perform the steps given below:
Warning
Read the wall-mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system.
Statement 378
Step 1 Locate the position where you plan to install the router.
Step 2 Ensure that there are no obstructions.
Step 3 Position the router with the ports facing up as in Figure 3-6, or down and align the bracket holes with
the holes on the wall and secure with four Number 6-32 x 0.25-inch mounting screws (two on each side).
Step 4 Tighten the screws using a 1/4-inch flat-blade screwdriver (each side).
Figure 3-6 Mounting the Router on a Wall
334584
1
1 User-supplied screws 2 —