Filter
Top Products
assembly
B. Find five 378" Pan Head Self-Treading screws from
among the loose parts.
7. Place Disc Dust Trap on your workbench and screw m
five Pan Head "Thread Cutting Screws," 3/8" long.
Screw them in all the way.
NOTE: The holes in the Trap are not threaded but the
screws are "Thread Cutting Screws" and will cut a
thread as they are tightened.
DISC DUST TRAP
R. Find four Flat Head Machine Screws 1-¾" long from
among the loose _arts
FLAT HEAD SCREWS
1 3/4" LONG
FLAT SPOT
/ONSHAFT
/
/
/
9. Attach the Disc Dos1 Trap with four flat head screws
!-¾" long.
10. There is a flat spot on the shaft near the end. Rotate
the shaft so that the flat spot is facing up.
/
/ /
11 Place the disc on the shaft so that the set screw ts
facmc up. Position the disc so that it is approx, 1/16
rich outward from the edge of the dust trap.
12 Insert the long end of me 532" setscrew wrench
through me hole in the disc housmg and mto the
setscrew n the disc. Make sure setscrew _s aligned
with "F ]at" on shaft.
TRAP
NOTE: After several hours of operation, check for
ooseness of setscrew and ret_gh[er
13. Make certain that the metal disc is free of oil and
grease then peel the backing from the 9" abrasive disc
and affix to the sanding disc.
5/32INCH
/--SETSCREW
/ WRENCH
\ \
\
10