Filter
Top Products
FINISHING CURVED EDGES ON THE
ABRASIVE BELT
CURVED EDGES
Finish outside curves on the abrasive belt and inside
curves on the idler pulley.
J
FINISHING SMALL END SURFACES AND
CURVED EDGES ON THE ABRASIVE DISC
Move the work across the "Down Side" of the face of
the abrasive disc. For accuracy, use a miter gauge_
NOTE: Use a combination square to square the miter
gauge to the face of the disc. If it is not squat e pull out
the index pin, loosen the miter gauge knob and move the
miter gauge slightly until it is square. Without moving "_
the miter gauge, tighten the knob securely.
\
Applying the workpiece to the "Up Side" could cause it
to fly up (kickback) which could be hazardous.
The table may be tilted for beveled work.
SQUARE
MITER GAUGE
/