Filter
Top Products
14. Remove the top right hand screw which VOU installed in
step 6 and loosen the other t_ree screws.
15. Install the Dust Trap cover and reD,ace me too right
hand screw. Tighten ag five screws.
TOP RIGHT HAND SCREW
DUST TRAP COVER
iNSTALLING MOTOR, V-BELT,
BELT GUARD
1. Locatethe followingparts:
OTY. Description
1
1
1
1
4
4
4
4
Motor
"L" Bracket
Pulley (approx. 2" Dia.)
V-Belt
Carriage Bolt 5/16-18 x 3/4
Flat Washer 5/16 I.D.
Lockwasher 5/16 I.D.
Hex Nut 5/16-18
AND
Guard Assembly including a guard support,
guard support bracket, self-threading screws,
and clips.
2. Place motor against the motor mounting bracket and
insert bolts through holes in motor base and then
through holes marked "X" in motor mounting bracket.
DO NOT TIGHTEN BOLTS AT THIS TIME. The "'L"
bracket which holds the guard support must be slid
between the motor base and the motor mounting
bracket so motor must be loosely assembled to bracket
at this time.
II
LOCKWASHER
CARRIAGE BOLT
5/t6-18 x 3/4
/
MOTOR
3. Slide long leg of "L" bracket between motor base and
motor mounting bracket. Then sandwich the "L" bracket
between the guard support bracket and the guard
support and fasten together with self-threading screws
as shown. Install clips onto belt guard support.
4. Install the 2" pulley onto the motor shaft flush with the
end of the shaft and tighten the set screw in the pulley
hub against the flat part of the motor shaft.
TWO HOLES
TOGETHER
CLIPS
BELT GUARD
SUPPORT BRACKET
10-32 X 1/2 IN,
SELF-THREADING'
SCREW
/_ BELT GUARD
SUPPORT
11