Filter
Top Products
24 25
24 25
4. Take the blade guard assembly and
locate the black sliding locking knob
(4) on the back of assembly. (Fig. T)
Fig. T
5. Insert the blade guard assembly
onto the riving knife so that the pin
(5) engages into slot (6) completely.
(Fig T-1)
6. Slide the locking knob (4) up and
press the guard assembly down so
that the entire assembly is flat on
the riving knife. Release the locking
knob (4).
7. Make sure that the assembly is locked
in place both in front and back.
Fig. T-1
Removing the blade guard and anti-
kickback pawl assembly (Fig. R, T-1)
To avoid injury from an accidental
start, make sure the switch is in
the OFF position and the plug is
disconnected from the power source
outlet.
1. With the blade elevation handwheel
raise the blade to the maximum
height.
2. Loosen the blade lock handle do not
pull on handle just turn and move the
handwheel to 90° on the bevel scale
.
3. Tighten the bevel lock handle.
4. Remove the anti-kickback pawl
assembly (3) by pressing the anti-
kickback pawls lever (1). (Fig. R)
5. Removing the blade guard assembly
(7) by pulling out the locking pin (4).
(Fig. T-1)
AVOID KICKBACKS (FIG. U)
(Work thrown back towards
you) by
keeping the blade sharp, the rip fence
parallel to the saw blade and by keeping
the riving knife, anti-kickback pawls and
guards in place, aligned and functioning.
Do not release work before passing it
completely beyond the saw blade. Do not
rip work that is twisted, warped or does
not have a straight edge to guide it along
the fence. Do not attempt to reverse out
of a cut with the blade running.
Improper riving knife alignment can
cause “kickback” and serious injury.
Fig. U
INSTALLING TABLE SIDE
EXTENSIONS (FIG. V)
1. Identify the right hand table extension.
NOTE: For illustration purposes the
view in Fig. V looks “through” the
saw table to the under side of the
table. The right hand table extension
is the one with the measuring scale
visible from the front of the saw
when it is installed to the right hand
side of the saw table.
WARNING
!
WARNING
!
Anti- kickback pawl
Loosen
1
2
4
4
5
6
7