Filter
Top Products
8 9
8 9
slip could cause your hand to move
into the saw blade.
15.NEVER USE SOLVENTS to
clean plastic parts. Solvents could
possibly dissolve or otherwise
damage the material. Only a soft
damp cloth should be used to clean
plastic parts.
16.MOUNT your table saw on a
bench or stand before performing
any cutting operations. Refer to
ASSEMBLY on page 20.
17.
Never cut metals or masonry
products with this tool. This table
saw is designed for use on wood
and wood-like products.
18.ALWAYS USE IN A WELL-
VENTILATED AREA. Remove
sawdust frequently. Clean out
sawdust from the interior of the saw
to prevent a potential fire hazard.
19.NEVER LEAVE THE SAW
RUNNING UNATTENDED. Do not
leave the saw until the blade comes
to a complete stop.
20.For proper operation follow the
instructions in this Operator’s Manual
entitled OPERATION (Page 34).
NOTE: On machines with no stand
or if stand is not being used, a hole
approximately 11 in. square must
be cut under saw to allow sawdust
to fall through. Failure to cut this
hole will allow sawdust to build up
in the motor area, resulting in a fire
hazard and potential motor damage.
21.USE ONLY saw blades recom-
mended with warning that the riving
knife shall not be thicker than the
width of the groove cut by the saw
blade and not thinner than the body
of the saw blade.
22.USE PUSH-STICK OR PUSH
BLOCK to feed the workpiece past
the saw blade. The push-stick or
push block should always be stored
with the machine when not in use.
23.Use and correct adjustment of the
riving knife.
WARNING
!