Filter
Top Products
24 25
24 25
NOTE:
●
The washers (1/4*1/2-3/32)
(5)
are
not included with this table saw. It
must be purchased separately.
● Riving knife thickness is 0.09 in.
●
The maximum radial distance
between the riving knife and the
toothed rim of the saw blade is 0.12
in ~ 0.31 in. (3 mm ~ 8 mm)
●
The tip of the riving knife shall not
be lower than 0.04 in. ~ 0.2 in. (1
mm ~ 5 mm) from the tooth peak.
●
The riving knife is thinner than the
width of the kerf by approximately
1/64 in on each side.
8. Check the riving knife and blade
alignment again at both 0° and 45°.
9. Add or remove the washers until the
alignment is correct.
10.Replace the table insert, blade guard
and anti-kickback pawl assembly.
Fig. Q
BLADE GUARD ASSEMBLY
(FIG. R, S, T)
To avoid injury from an accidental
start, make sure the switch is in
the OFF position and the plug is
disconnected from the power source
outlet.
● When installing the blade guard,
cover the blade teeth with a piece
of folded cardboard to protect
yourself from possible injury.
● Never operate this machine
without the blade guard in place
for all through sawing operations.
Installing the blade guard and anti-
kickback pawl assembly (Fig. R, S, T)
1. Make sure the blade is elevated to
its maximum height and the bevel is
set at 0°. Make sure the bevel lock
handle is tight.
2. Take the anti-kickback pawl
assembly and lift up the locking
lever (1) located on top. (Fig R)
3. Place the front of assembly into slot
(2-Fig R) and push down making
sure the assembly is engaged in the
slots. There should be no movement
of the assembly. Push down on the
locking lever (1). (Fig S)
Fig. R
Fig. S
4
1
2
3
5
WARNING
!
Loosen
1
2
Tighten
1
3