Filter
Top Products
• Usingan6mmkey,loosenthesockethead
screwssecuringthefence.See Figure 16.Adjust
thefence left or rightuntiltheframingsquare and
zero clearancethroat plataare parallel.
• Retightenthe screws securely and recheckthe
fence-to-tablealignment.
6 mmSOCKETHEAD
SCREW(S)
6 mmSOCKETHEAD
SCREW(S)
Fig. 16
SQUARING THE SAW BLADE TO THE
FENCE
See Figures 17- 20.
• Unplugyour saw.
_l, WARNING: Failureto unplugyoursaw could
resultin accidental startingcausingpossible
sedouspersonal injury.
Pullthe saw arm all the way down and engage
the lockpinto holdthe saw arm in transport
position.
Loosen the miter lock handle approximately
one-half turn.
Depress the miter lock prate and rotate the miter
table untilthe pointer on-the control arm is
positionedat 0°.
Release the miter lockplate and securelytighten
the miterlock handle.
Lay a framing square flaton the mitertable. Place
one legof the squareagainst the fence. Slide the
other legof the square againstthe fiatpart of saw
blade.
Note: Make sure that the square contactsthe flat
partof the saw blade, notthe bladeteeth.
FENCE
FENCE
FENCE
MITER FRAMING
TABLE SQUARE
VIEWOFBLADE
SQUAREWITHFENCE
MITER
LOCKHANDLE
Fig. 17
MITER FRAMING
TABLE SQUARE
VIEWOFBLADENOTSQUAREWITH
FENCE,ADJUSTMENTSAREREQUIRED
Fig, 18
BLADE
MITER FRAMING
TABLE SQUARE
VIEWOFBLADENOTSQUAREWITH
FENCE,ADJUSTMENTSAREREQUIRED
Fig. 19
16