Filter
Top Products
WARNING:Whenservicing,usaonlyidentical
Craftsmanreplacementparts.Useofanyother
partmay create a hazard orcause product
damage.
GENERAL
Avoidusingsolventswhen cleaningplasticparts.
Most plasticsare susceptibleto damage fromvadous
typesof commercialsolventsand may be damaged
bytheir usa. Usa clean clothsto remove dirt,carbon
dust,etc.
EXTENSION CORDS
The usa of any extensioncordwillcause some lossof
power.To keep the lossto a minimumand to prevent
tooloverheating, usa an extensioncordthat isheavy
enoughto carry the currentthe toolwill drew.
Awire gage size (A.W.G.) ofat least 14 is recom-
mendedfor an extensioncord 25 feet or less in
length.When workingoutdoors,usa an extension
cordthat is suitablefor outdoorusa. The cord's jacket
will be markedWA.
,_ WARNING: Do notat any time let brake fluids, _ cuttingCAUTION:areaandKeeppositionextensi°nthecordScordsoaWaythatfromitwillthe
gasoline,petroleum-basedproducts,penetrating notget caught on lumber,tools, etc., dudng
cuttingoperation.
oils,etc. come in contact with plastic parts.They
containchemicalsthat can damage, weaken or
destroyplastic.
it has been foundthat siectric toolsare subjectto
acceleratedwear and possibleprematurefailurewhen
they are used onfiberglassboats,sportscars,
wallboard,spacklingcompounds, or plaster.The
chipsand gdndingsfromthese matedals are highly
abrasiveto siectdc tool parts suchas bearings,
brushes,commutators, etc. Consequently,it is not
recommendedthat thistoolbe usedfor extended
work on anyfiberglass material,wallboard,spackling
compounds,or plaster. Duringany use on these
matedaisit isextremelyimportantthat the tool is
cleanedfrequentlyby blowingwithan air jet.
LUBRICATION
WARNING: Check extensioncords before each
usa. If damaged, replace immediately.Never usa
toolwitha damaged cord since touchingthe
damaged area could cause electdcalshock
resultingin sedousinjury.
_k WARNING: Alwayswear safety gogglesor
safety glasses withside shieldsdudngpower
tooloperation or when blowingdust.Ifoperation
is dusty,also wear a dust mask.
Allof the bsadngs inthis tool are lubricatedwith a
sufficientamount of highgrade lubricantforthe lifeof
the unitunder normaloperatingconditions.Therefore,
no further lubricationis required.
27