Filter
Top Products
_lb WARNING: To ensure safety and reliability,all
repairs-- with the exceptionof the extemally
accessiblebrushes_ shouldbe performedbya
qualifiedservice technicianat a Sears storeto
avoid riskof personalinjury.
BRUSH REPLACEMENT
See Figure 36.
BRUSH
ASSEMBLY
BRUSH
CAP
BRUSH
CAP
_BRUSH
ASSEMBLY
Fig. 36
Your saw has externally accessiblebrushassemblies
that shouldbe pehodicallycheckedforwear.
Proceed as follows when replacement Is required:
• Unplugyour saw.
_kWARNING: Failureto unplugyour saw could
resultin accidentalstartingcausingsadous
injury.
• Remove brushcap with a screwdriver.Brush
assembly is spdngloaded and willpop outwhen
you remove brushcap.
• Remove brushassembly.
• Check for wear. Replace both brusheswhen
eitherhas less than 1/4 in.lengthof carbon
remaining.Do not replaceone side without
replacingthe other.
• Reassemble usingnew brushassemblies.Make
sure curvatureof brush matchescurvatureof
motorand that brushmovesfreelyin brushtube.
• Make surebrushcap is odented correctly ,
(straight)and replace.
• Tighten brushcap securely. Do not overtighten.
28