Filter
Top Products
When cuttingcrownmoldingby thismethodthe bevel
angle shouldbe set at 33.85°. The miter angleshould
be set at 31.62° either dghtor left, dependingonthe
desiredcutfor the application.See thechart belowfor
correctangle settingsand correct positioningofcrown
moldingon mitertable.
The settingsin the chart belowcan be used forcutting
AllStandard (U.S.) crownmoldingwith 52° and 38°
angias. The crown moldingisplaced fiat on the miter
table usingthe compound features ofyour mitersaw.
Bevel
Angle Type of Cut
Setting
Left side, Inside corner
1. Top edge of moldingagainstfence
33'85° 2. Miter table set dght 31.62°
3. Save leftend of cut
I
Right side, Inside corner
1. Bottomedge of moldingagainst fence
33"85° 2. Mitertable set left31.62°
3. Save leftend of cut
Left side, outside comer
1.Bottomedgeofmoldingagainst fence
33"85° 2. Mitertable set left31.62°
3. Save rightend of cut
Right side, outside comer
1. Top edge of moldingagainstfence
33"85° 2. Mitertable set dght31.62 °
3. Save dghtend ofcut
CUTTING WARPED MATERIAL
See Figures 33 and 34.
WRONG Fig. 34
When cuttingwarped material,always make sure itis
positionedon the mitertable with the convex side
againstthe fence as shown infigure 33.
Ifthe warped matadai is positionedthewrong way as
showninfigure 34, it willpinchthe bladenear the
completion of the cut.
_lb WARNING: To avoida kickbackand to avoid
serious personalinjury,never positionthe
concave edge ofbowed or warped material
againstthe fence.
CLAMPING WIDE WORKPIECES
See Figure35.
WIDE
BOARD
RIGHT Fig. 33 Fig. 35
When cuttingwide workpiecas such as a 2 in. x 6 in.,
boards shouldbe clampedwith a C-clamp as shownin
figure 35.
26