Filter
Top Products
10 308–293
Setup
3. Flush the Spray Gun.
Before
running any paint through the spray gun, flush
the gun out with a solvent that is compatible with the
fluid to be sprayed, using the lowest possible fluid
pressure and a grounded metal container
.
Fig. 5
02053
WARNING
PRESSURIZED EQUIPMENT HAZARD
T
o reduce the risk of a serious injury whenever you
are instructed to relieve pressure, follow the
Pres-
sure Relief Procedure
on page 13.
4. Relieve the Pressure.
5. Position the Air Cap
Rotate
the air cap as needed to achieve the desired
spray pattern direction. T
o create a round pattern, turn
the pattern air of
f by turning the pattern adjustment
knob (13a) fully clockwise. Refer to Fig. 12.
Vertical Pattern
Horizontal Pattern
Fig.
6
02020
6. Adjust the Spray Pattern
WARNING
COMPONENT
RUPTURE HAZARD
Do not exceed the
100 psi (0.7 MPa,
7 bar) maximum fluid and air pres
-
sure
of this gun. Higher pressures can cause parts
to rupture and result in serious injury
.
Follow these steps to establish the correct fluid flow
and air flow:
A. T
urn the fluid adjustment knob (8)
counterclock-
wise until no restriction of the trigger movement is
felt, then turn the knob another half turn. When the
knob is turned far enough, the trigger should be
able to touch the gun handle when the gun is trig
-
gered.
02017
Fig. 7
8
open