Filter
Top Products
G1022 Series Table Saws -19-
Beginning Assembly Stand Assembly
TOOLS REQUIRED: High quality square and
straightedge, metric Allen wrench set, flat screw-
driver, Phillips screwdriver, dead blow hammer
and a 6" or 8" adjustable wrench.
Loose hair and clothing
could get caught in
machinery causing seri-
ous personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly.
Figure 9. Installing the rubber feet.
To assemble the stand:
1. Fasten the rubber feet to the leg bottoms
using M10-1.5 x 25 hex bolts, 10MM flat
washers and M10-1.5 hex nuts as shown in
Figure 9.
2. Bolt the long upper and lower side braces (2
each) to the legs using M8-1.25 x 16 car-
riage bolts, 8MM flat washers and M8-1.25
hex nuts as shown in Figure 10. Do not com-
pletely tighten the hex bolts at this time.
Examine the edges of all
metal parts before han-
dling. Sharp edges on
metal parts may cause
personal injury.
Disconnect the machine
power cord during
assembly. Failure to fol-
low this warning could
result in serious person-
al injury or death.
!