Filter
Top Products
G1022 Series Table Saws -35-
Before starting the machine:
1. Read this manual and make sure you take all
safety precautions before operating this
machine.
2. Make sure the blade guard and splitter have
been correctly installed and are adjusted
properly as shown on Pages 30-31.
3. Make sure that any tools or foreign objects
have been removed from the machine.
4. Review Section 3: Circuit Requirements
beginning on Page 9 and make sure all
wiring is correct.
5. Keep your finger on the STOP button during
the entire test run of the machine.
Starting the machine:
Turn the machine on and make sure your hand is
on the STOP button in case you need to shut the
machine off immediately. The machine should
run smoothly with little or no vibration.
Start Up Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
However, because of the many variables
involved with shipping, we recommend that you
at least check the following adjustments to
ensure the best possible results from your new
machine.
All of these adjustments are covered in step-by-
step detail in Section 8: Service Adjustments.
Recommended adjustment checklist:
• Blade Parallelism (Page 49)
• 45˚ Blade Stop (Page 52)
• 90˚ Blade Stop (Page 52)
Loose hair and clothing
could get caught in
machinery causing seri-
ous personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly.