Filter
Top Products
G1022 Series Table Saws -49-
Blade Parallelism
To check and adjust blade parallelism:
1. Disconnect the machine from the power
source!!
2. Tilt the blade to 90˚. Using an adjustable
square, measure the distance (A) between
the miter slot and the front of the blade as
shown in Figure 59.
The Model G1022 Series Table Saws will perform
best when the miter slot is parallel to the blade.
Figure 59. 90° blade parallelism measurement.
Figure 60. 90° blade parallelism measurement.
3. Rotate the blade 180° and measure the dis-
tance (B) between the miter slot and the
back of the blade as shown in Figure 60.
Use caution and remain
alert when working
around the saw blade.
Failure to follow this
warning could result in
serious personal injury
or death.
SECTION 8: SERVICE ADJUSTMENTS
!
!