Filter
Top Products
-34-
G1022 Series Contractor Saws
Miter Gauge
Initial Step Models ZF, ZFX, PROZ, & PROZX:
The miter gauge for the Models ZF, ZFX, PROZ,
& PROZX has two setscrews in the miter bar
which can be set to remove any loose movement
between the miter bar and the T-slot.
Loosen or tighten the two setscrews until the
miter gauge slides freely in the slot, but has no
loose movement.
Next steps for all models:
1. Loosen the lock knob on the miter gauge and
place a square against the face of the miter
body and the miter bar.
2. Adjust the miter body until there is no space
between the square and the miter bar.
3. Tighten the lock knob.
4. With the stop link (
Figure 43
) in the up posi-
tion, loosen the jam nut and adjust the stop
screw until it is seated against the stop link.
5. Loosen the setscrew on the left front side of
the miter bar, adjust the pointer to 90˚ and
retighten the setscrew.
6. To adjust to 45˚, follow Steps 1-5 while using
an adjustable square.
7. After rotating the miter body from 45˚ to 90˚
and back a few times, double check your
adjustments at both angles to ensure that
you have accurately set your miter gauge.
Figure 43. Miter gauge adjustment points.
Stop Link
Jam Nut
Stop Screw