Filter
Top Products
G1022 Series Table Saws -33-
Table Insert
The table insert provides support for the material
being cut. It must be installed flush with the cast
iron table surface.
To install the table insert:
1. Disconnect the machine from the power
source!
2. Using the front handwheel, move the blade
to its lowest position.
3. Set the table insert into the recessed area on
the table surface.
4. Ensure that all four table insert setscrews are
firmly in contact with the table casting.
5. Using an allen wrench, raise or lower each of
the four setscrews until the insert is flush
with the table top as shown in
Figure 42
.
6. Using the side handwheel, position the blade
90° to the table surface.
7. Wearing leather gloves, rotate the blade while
raising and lowering it through its full range of
motion. Make sure it never contacts any part
of the table insert.
8. Repeat Step 6 with the blade in the 45° posi-
tion.
Figure 42. Adjusting table insert components.
Setscrew
Allen Wrench
Table Insert
Wear leather gloves
when rotating the saw
blade. Failure to follow
this warning could
result in serious per-
sonal injury or death.