Filter
Top Products
-30- G1022 Series Table Saws
To install a saw blade:
1. Disconnect the machine from the power
source!!
2. The arbor nut has left-hand threads.
Unthread the arbor nut clockwise and
remove the outside flange from the arbor.
Remove and discard the
3
⁄4'' diameter spacer
on the arbor shaft.
4. Slide on the flange and thread the arbor nut
back on.
5. Use the arbor wrench provided with the saw
to tighten the arbor nut. Wedge a block of
wood in the teeth of the blade to keep it from
turning when tightening the nut as shown in
Figure 35.
3. Install the saw blade onto the arbor. Ensure
that the blade teeth point toward you as you
stand at the front of the saw.
Use caution and remain
alert when working with
the saw blade. Failure
to follow this warning
could result in serious
personal injury or
death.
Blade
Figure 35. Changing saw blade.
!