Filter
Top Products
-22- G1022 Series Table Saws
3. Set the motor on end and slip the pulley
guard bracket between the base of the motor
and the motor plate as shown in Figure 17.
Figure 17. Installing pulley guard.
4. Tighten 1 of the 4 mounting bolts. Leave the
other 3 loose.
5. Locate the motor mount bracket shown in
Figure 18. Loosen the setscrew that holds
the motor pivot rod in place and remove the
rod.
Figure 15. Attaching the motor plate.
To mount the motor:
1. Turn the motor upside down and attach the
motor plate using M8-1.25 x 25 hex bolts,
8MM flat washers and M8-1.25 hex nuts as
shown in Figure 15. Finger-tighten only.
Motor
Figure 16. Pulley guard bracket.
2. Insert the
1
⁄4''-20 x 2'' hex bolt through the
hole in the pulley guard bracket as shown in
Figure 16.
The motor comes
pre-wired.
Motor Mount Plate
Motor Mount Plate
1
⁄4''-20 x 2'' Hex Bolt
Pulley Guard Bracket
Pulley Guard Bracket
Motor pictures shown are specific to the
Models SM & Z. The Models ZF, ZFX, PROZ,
& PROZX will look different but will assem-
ble in the same way.
NOTICE