Filter
Top Products
-26- G1022 Series Table Saws
The fence must engage and square up on the
front rail before the rear clamp engages the back
rail. In essence, the rear clamp should act as a
secondary mechanism for maintaining fence
position. When adjusted correctly, the lever lock
should only begin to apply pressure on the back
rail over the last one-third of its stroke.
To install and adjust the Model SM fence:
1. Thread the plastic knob onto the lock handle.
2. Slide the fence onto the rails.
3. Make sure the front clamp engages the front
rail with the lock handle at one-half of its
throw.
4. If the front clamp requires adjustment,
loosen the check nut shown in Figure 25.
Turn the adjusting bolt clockwise if the front
clamp is too far from the rail, or counter-
clockwise if it is too close.
Figure 24. Attaching fence rails.
Fence Rails
To mount the rails (Models SM & Z):
The two center bolts for each rail thread directly
into the table top, and the outer two bolts secure
from the back side of the extension wing with hex
nuts.
Place a spacer on each bolt between the rail and
the table/wing edge as shown in Figure 24.Be
sure that the rail with the built-in measuring rule is
mounted on the front side of the machine, with
the markings facing up. Insert the round, plastic
plugs into the ends of each rail.
Fence
The Models SM & Z are supplied with
round rails, the Models ZF, ZFX, & PROZX
are supplied with flat angular bar sections
and the Model PROZ is supplied with
square tube rails. This accommodates the
standard fence for the Models SM & Z, the
SHOP FOX
®
Heavy-Duty fence for the
Models ZF, ZFX, & PROZX, and the SHOP
FOX
®
Classic fence for the Model PROZ.
Please refer to the SHOP FOX
®
manuals for
complete information regarding the instal-
lation of the front and back fence rails on
the Models ZX, ZXF, PROZ, & PROZX.
NOTICE
The Models ZX, ZXF, PROZ, & PROZX use a
SHOP FOX
®
brand fence. Please refer to the
manual included with the SHOP FOX
®
fence
for adjusting instructions.
NOTICE
Figure 25. Adjusting clamp mechanism.
Check Nut
Adjusting Bolt