Filter
Top Products
G1022 Series Table Saws -51-
3. Tighten down one trunnion bolt a small
amount and then move on to each of the
others, tightening each down the same
amount.
4. Continue to rotate through the bolts, tight-
ening them a little each time until they are
all secure.
5. Re-assemble the saw assembly onto the
stand.
6. Recheck the blade to miter slot distance at
90° and 45°. If the distance of A and B are
equal to or less than 0.004" at both 90° and
45°, continue to the next section. If the dis-
tances are still off by more than 0.004",
repeat the previous procedures.
7. Once you feel you have the miter slot
adjusted parallel to the blade, recheck all
measurements and be sure the table
mounting bolts are secure.
8. Repeat Step 10 on Page 31.
To shim the trunnion:
1. Loosen the trunnion bolts.
2. Using Figures 63 & 64, shim the trunnion
assembly according to the difference mea-
sured when the blade was in the 45˚ posi-
tion.
If the distance of A is shorter than B, shim(s)
will need to be placed under corners #1 and
#2.
If the distance of B is shorter than A, shim(s)
will need to be placed under corners #3 and
#4.
Figure 64. 45°
blade parallelism measurement.
#1 Shim
#3 Shim
#2 Shim
Figure 63. 45°
blade parallelism measurement.
#1 Shim
45˚ Bevel
45˚ Bevel
#3 Shim
#4 Shim
#4 Shim
#2 Shim
If the trunnion assembly is loosened in the
future, make note of the shim locations
and re-assemble accordingly.
NOTICE
!
!