Filter
Top Products
G1022 Series Table Saws -27-
Figure 26. Rear lock adjustment screw.
5. Slide the fence along the rail until it is
aligned with the edge of the miter slot.
6. Lock the fence down.
7. Loosen the rear lock adjustment, the slotted
screw on the front of the fence shown in
Figure 26, until the rear locking clamp ceas-
es to engage the rear rail with the fence in
the locked position.
Rear Lock Adjustment
6. Loosen the adjustment bolts at the top of the
fence shown in Figure 27.
8. Move the straight portion of the fence until it
is parallel with the miter slot from front to
back. Retighten the bolts.
9. Loosen the locking handle until it is approxi-
mately two-thirds engaged.
10. Tighten the rear adjusting screw until the
rear clamp barely touches the back rail.
11. Loosen the locking handle and slide the
fence along the rail. Return the fence to its
position at the edge of the miter slot and
slowly apply pressure to the lever.
If adjustments are correct, the fence should
square itself before the rear clamp engages.
If the rear clamp engages before the fence is
squared, loosen the screw one-quarter turn
and retest.
12. Once the fence is adjusted, check the mea-
surement pointer shown in Figure 28 and
adjust if necessary.
Figure 27. Adjustment bolts for
fence parallelism.
Adjustment Bolts
Figure 28. Adjust measurement pointer.
Measurement Pointer