Filter
Top Products
G1022 Series Table Saws -29-
7. Make note of its position and lift it up all the
way. Tighten the rear adjustment screw until
the rear clamp is approximately
1
⁄16'' from the
rail.
8. Move the lock handle back to its two-thirds
position. The rear clamp should just be
touching the rail. If it is too loose or too tight,
lift the handle and turn the adjusting screw in
small increments until the clamp is in its
proper location.
9. Loosen the locking handle and slide the
fence along the rail. Return the fence to its
position at the edge of the miter slot and
slowly apply pressure to the handle.
10. If adjustments are correct, the fence should
square itself before the rear clamp engages.
If the rear clamp engages before the fence is
squared, loosen the screw one-quarter turn
and retest.
Figure 32. Adjustment bolts for
fence parallelism.
Front Adjustment Screws
Locking Handle
6. Loosen the locking handle (Figure 32) until it
is approximately two-thirds engaged.
Do not turn the adjustment screw unless
the lock handle is in the up position.
Damage to the clamp shoe will result if this
step is not observed.
Figure 33. Adjust measurement pointer.
11. Once the fence is adjusted, check the mea-
surement pointer shown in Figure 33, and
adjust if necessary.
Measurement Pointer
Figure 34. Attaching a sacrificial fence.
Tip: Attach a piece of
3
⁄4" thick hardwood to
the blade side of the fence as shown in
Figure 34. This will keep thin materials from
wedging between the fence and table and will
also protect the fence from coming in contact
with the blade when dadoing or ripping thin
stock. Remember to flip and adjust the mea-
surement scale on the rail to compensate for
the thickness of the sacrificial fence.
Wood Screws
Rip Fence
Sacrificial Fence
NOTICE