Filter
Top Products
G0644 15" Open-End Wide Belt Sander
-15-
The center of gravity of the assembled sander is
above the middle of the machine. Although not
required, we strongly recommend that you mount
your new machine to the floor to prevent tipping.
Because this is an optional step and floor mate
-
rials may vary, floor mounting hardware is not
included.
Bolting to Concrete Floors
Anchor studs and lag bolts (Figure 8) are two
popular methods for anchoring an object to a con
-
crete floor. We suggest you research the many
options and methods for mounting your machine
and choose the best that fits your specific applica
-
tion.
Mounting to Shop
Floor
NOTICE
Anchor studs are stronger and more perma-
nent alternatives to lag bolts; however, they
will stick out of the floor, which may cause
a tripping hazard if you decide to move your
machine
.
Figure 8. Typical fasteners for mounting to
concrete floors.
Anchor Stud
Lag Anchor & Bolt
Moving &
Assembling Sander
The Model G0644 is a
heavy machine. Serious
personal injury may occur
if safe moving methods
are not used. To be safe,
get assistance and use
power equipment to move
the shipping boxes and
remove the machine from
the boxes.
To move the machine:
1. Mount the cabinet stand to the floor in your
prepared location using the four mounting
holes found inside the cabinet.
2. Remove the four M8-1.25 x 25 hex bolts
and flat washers from the top of the cabinet
stand.
3. Place the forklift forks in a stable position
under the conveyor, as shown in
Figure 9.
Figure 9. Forklift forks positioned under sanding
assembly.