Filter
Top Products
-36-
G0644 15" Open-End Wide Belt Sander
Replacing Conveyor
Belt
Contact Grizzly Customer Service at (800) 523-
4777 to obtain a replacement conveyor belt (Part
Number P0644024).
To replace the conveyor belt:
1. DISCONNECT THE SANDER FROM
POWER!
2. Use a 4mm hex wrench to remove the M4-.7
x 10 cap screws and flat washers securing
the front and rear conveyor roller guards (see
Figure 40), then remove the guards.
3. Use a 10mm wrench to loosen the con-
veyor adjusting jam nuts (left and right), then
release the tension on the conveyor belt by
loosening the tension adjusting hex bolts
(see Figure 41).
4. Use a 5mm hex wrench to remove the three
M8-1.25 x 18 button head cap screws secur
-
ing the
left front conveyor roller bracket (see
Figure 41), then, while supporting the front
conveyor roller assembly, remove the brack
-
et.
5. Carefully pull the front conveyor roller assem-
bly from the conveyor belt and the right front
roller bracket.
NOTICE
Take care not to scratch or dent the front
conveyor roller as you remove it from the
sander. Damage to the conveyor roller could
result in premature wear of the conveyor
belt.
Figure 41. Conveyor belt tensioning fasteners
and front roller bracket.
Tension
Adjusting
Hex Bolt
Front Roller
Bracket
Button Head
Cap Screws
Jam Nut
Figure 40. Conveyor roller guards and sanding
assembly mounting brackets.
Rear Conveyor
Roller Guard
Front Conveyor
Roller Guard
Sanding Assembly
Mounting Brackets
& Hex Bolts