Filter
Top Products
G0644 15" Open-End Wide Belt Sander
-19-
Figure 16. Removing switch key from conveyor
toggle switch.
13. Try to start the conveyor by flipping the toggle
switch to the ON position.
—If the conveyor does not start, the switch
disabling feature is working as designed.
—If the conveyor starts, immediately stop the
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
14. Press the Emergency Stop button to turn
the sanding motor
OFF, re-install the switch
disabling key, and reset the Emergency Stop
button.
15. Disconnect the compressed air from the
sander and attempt to turn the sanding motor
ON.
—If the machine does not start, the air pres
-
sure safety switch is working correctly.
—If the machine does start (with the air pres
-
sure disconnected), immediately discon
-
nect power to the machine. The air pres
-
sure safety switch is not working correctly.
This safety feature must work properly
before proceeding with the rest of the
test
run. Call Tech Support for help.
11. Turn the conveyor ON and verify that it oper-
ates correctly.
12. Turn the conveyor belt OFF, and remove the
switch disabling key, as shown in
Figure 16.
For your convenience, the adjustments listed
below have been performed at the factory and
no further setup is required to operate your
machine.
However, because of the many variables involved
with shipping, some of these adjustments may
need to be repeated to ensure optimum results.
Keep this in mind as you start to use your new
drum sander.
Step-by-step instructions for these adjustments
can be found in the SERVICE section of this
manual
.
• Conveyor Belt Tensioning (Page 30).
• Conveyor Belt Tracking (Page 31).
• Gib Adjustment (Page 31).
• Sanding Drum & Conveyor Parallelism (Page
32).
• Air Pressure Safety Switch (
Page 33).
• Depth Of Cut Safety Bar (
Page 33).
• Pressure Rollers (
Page 34).
Recommended
Adjustments