Filter
Top Products
-16-
G0644 15" Open-End Wide Belt Sander
4. With an assistant to steady the sanding
assembly on the forks, lift and move it into
position over the cabinet stand so that the
mounting holes line up (see
Figures 10 &
11).
Figure 11. Mounting bolts (right side).
Mounting Bolts
5. Secure the sanding assembly to the cabinet
stand with the four
hex bolts and flat washers
removed in Step 2
.
6. Remove the four 10-24 x 3/8" cap screws and
flat washers from the front of the conveyor,
slide the conveyor front roller guard onto the
conveyor, and secure it with the cap screws
and flat washers (see
Figure 10).
7. Open the sanding belt access door on the
left side of the machine, and remove the red
shipping brace securing the sanding drum
and the conveyor assembly (see
Figure 12).
Figure 10. Mounting bolts and conveyor front
roller guard (left side).
Conveyor Front
Roller Guard
Figure 12. Location of the shipping brace.